In surface-mount assembly, solder paste is deposited through a stencil onto PCB pads before components are placed and reflowed. Inconsistent paste volume or position can contribute to opens, bridges, skew or other defects. A buyer does not need to design the stencil alone, but should ask how the process is matched to the board and component mix.

Review aperture design against the assembly
Stencil apertures are related to pad geometry, component pitch, solder volume and thermal behavior. The assembler may propose reductions, step areas or other changes for fine-pitch or mixed-size components. Ask for a marked-up proposal and review it with the design owner, especially where solder volume affects electrical or mechanical performance.
Confirm paste and handling assumptions
Identify the specified paste alloy and any storage or working-time constraints that apply. Ask how paste is conditioned, mixed, loaded and monitored on the production line. Requirements vary by material supplier and process; follow the product data sheet rather than using generic handling assumptions.
Understand print inspection and correction
Ask whether solder paste inspection is used and which defects or measurements trigger a response. Confirm how board support, stencil cleaning and alignment are controlled. If a print is out of limits, define whether the board is cleaned and reprinted, held for review or scrapped. Track recurring print issues by board revision and line conditions.
Use pilot data to improve the release
For a new assembly, review early defect trends and correlate them with stencil, placement and reflow conditions. Approve changes through engineering revision control; do not let a process tweak alter the product definition without visibility. Record the approved stencil revision and storage/maintenance responsibility.
Ask the EMS provider to explain its print process in relation to the board’s actual package mix. A focused discussion can identify manufacturing risks before a large build.