Injection-molded parts can change dimension as resin cools and solidifies. Shrinkage is influenced by material, geometry, gate and cooling design, and process conditions. A drawing that applies tight tolerances without considering these variables can lead to expensive tooling changes or inconsistent acceptance.

Identify dimensions that control function
Separate critical interfaces from cosmetic or non-functional dimensions. Focus on mating features, sealing surfaces, alignment points and snap fits. State datum references and measurement conditions clearly. If a part is measured immediately after molding or while constrained in a fixture, the result may differ from a conditioned, free-state measurement.
Understand material and geometry effects
Different resin grades shrink differently, and fillers can change direction-dependent behavior. Thick sections, ribs, bosses and abrupt wall transitions may cool unevenly and contribute to sink or warpage. The molder may adjust gate position, packing, cooling or local geometry. Treat these proposals as design changes that need engineering review.
Specify sampling and measurement conditions
For critical dimensions, agree sample quantity, cavity identification, conditioning time and instruments. Make sure measurement points and part orientation are consistent. Inspect representative samples from each cavity when the tool is multi-cavity. A dimensional report should include measured values and trace them to the drawing revision, material and process condition.
Plan the tool correction loop
Early samples may require controlled adjustments. Before tooling starts, agree how feedback is documented, who approves steel changes and how many sampling rounds are included. Preserve the approved sample and final data. If resin or process settings change later, assess whether important dimensions need revalidation.
Do not treat a general shrinkage factor as a substitute for a qualified molding trial. Have the product designer and molder agree a realistic tolerance scheme for the selected resin and application.